EM Gauge 70's - November Update

Kier Hardy

Active Member
Most if not all miniature lathes have (or used to have) a full set of collets with which to hold the workpiece, and are much more accurate than a 3-jaw chuck for small stuff.
workshop_lathe01.jpg workshop_lathe02.jpg
This Pultra has a wide selection of collets to hold all manner of items. The 3-jaw chuck has reverse-able jaws and can hold items nearly 3 inches in diameter if required.

Thanks for your comments regarding the website - we enjoy sharing our modelling with you and hope the variety and content holds some interest for most of us on here.

All the best, Kier & Chums
 
Top