They only mention them on page 16 on the BR 1B/C instructions, I realise where they go now, still haven't found where 068 goes yet.
Len
Hi Kev, it doesn't say this in the instructions, I will try and phone Dave sharp next week as one of the tender wheels doesn't unscrew.068 looks very like the adjustment for the tender to loco drawbar distance. This from memory.
Kev
Hi Kev, it doesn't say this in the instructions, I will try and phone Dave sharp next week as one of the tender wheels doesn't unscrew.
Len
Hi Mark I emailed Dave Sharp about the discrepancy in the instructions, so he doing an update.Watch some of the photos on the tender instructions. I'm sure some of them are the BR2/2a tender from the 2-6-0 4mt kit which is a very similar construction but not 100% identical. I seem to remember reading a note about it somewhere.
Hi Mark I emailed Dave Sharp about the discrepancy in the instructions, so he doing an update.
Len
The instructions are a lot better than the other kits I have built. It's good that he updates them.He will end up re-writing the whole book if he does many more updates lol....
The original instructions were very rushed though.
I can remember him telling me when I brought my kits that they would need a few updates...
Once you have built a couple of his kits you get to know his techniques for doing things so its not so much of a problem.
The instructions are a lot better than the other kits I have built. It's good that he updates them.
Len
Thanks Gents
It will be a while before I attempt mine - need a bit more practice with 'lesser' wagon and loco kits before 'going large'!
Dave
Er, make the tabs on the casting smaller to fit?how to make them bigger?