7/8ths scale Slate Wagons

[Martin Shaw]

There is a forum dealing with 7/8" scale:
Login
Its not open access so you have to join (free) but you might find something of interest.

Thanks Phil, I have registered for it.
Martin

 

[michael080]

As a matter of interest since Fitzroy raised the matter I went and measured the centre section of all the axles. This is supposed to be 40.00mm however since it is a derived length by virtue of the manufacturing process it is the most likely to be variable and wrong. It is also critical since it determines the wheel back to back dimension.
Of the 12,
1 is 39.98
3 are 40.00
1 is 40.02
1 is 40.06
6 are 40.08

which gives a variation of 0.01mm or half a thou, and ignorable. Tick.
Martin

I hope you did repeat every measurement at least 12 times.

 

[Martin Shaw]

No Michael, I use the Glaswegian measurement system, it's only a baw hair out so it'll do. No need to bother now with that new fangled metric system.

 

[Martin Shaw]

Things ground to a halt for a while whilst I was somewhat unwell for 10 days, details are unimportant however following John's very useful post about couplings I bought some. I made up the first pair today from these Talisman castings.


The shackle is inserted into the gap in the hook and squeezed tight. The joint is then silver soldered and dressed. I overdid the solder on one but some careful application of heat sorted it out, and I notice from the following pic one coulde be redone. To fix it to the wagon I bought some 1/2" x 8BA screws with 9BA hex heads and then had to make some near matching 9BA nuts with an 8BA thread. Not quite micro engineering but small enough thank you, they seem to have turned out alright.