Latest activity
-
Recently finished one of these TRS Trains 3D printed 75t crane kit. It's not bad but a few mods had to be done. Still a few little bits... -
Dog Star replied to the thread SimonD’s workbench.The surface finish of the FDM printing that Nick has done for me is close to the results of resin printing which is done here. -
Alan reacted to Flaxfield's post in the thread Tales from The Room of Doom. Dipping a toe in various bucolic backwaters. with
Like.
Evening all. A little project has been signed off this evening. I acquired a W&M Railbus direct from Heljan. Despite running in, far... -
Well, I’ve not posted much on here for a few weeks, but I took the smoke box door off, soldered it to a mandrel and turned the back edge...
-
A day off work on a rainy day meant there was nothing else to be done than finish the LEWIS wagon! I started with the smaller lettering... -
As far as I can tell, the fitting of a small casting has completed construction of the chassis. The casting in question represents the...
-
Recently finished one of these TRS Trains 3D printed 75t crane kit. It's not bad but a few mods had to be done. Still a few little bits...
-
martin_wynne replied to the thread SimonD’s workbench.@simond Hi Simon, For a less obtrusive top surface finish you might like to experiment with the concentric setting in Bambu Studio... -
-
Well, I’ve not posted much on here for a few weeks, but I took the smoke box door off, soldered it to a mandrel and turned the back edge... -
Well, I’ve not posted much on here for a few weeks, but I took the smoke box door off, soldered it to a mandrel and turned the back edge...
-
Recently finished one of these TRS Trains 3D printed 75t crane kit. It's not bad but a few mods had to be done. Still a few little bits... -
A day off work on a rainy day meant there was nothing else to be done than finish the LEWIS wagon! I started with the smaller lettering...
-
Well, I’ve not posted much on here for a few weeks, but I took the smoke box door off, soldered it to a mandrel and turned the back edge...
-
Geoff reacted to James's post in the thread 7mm F*** Parkinson's - Occasional 7mm Workbench with Like.
I've fitted the main body side handrails but soldering them to their brackets in situ as it proved much easier than the jig provided... -
Geoff reacted to James's post in the thread 7mm F*** Parkinson's - Occasional 7mm Workbench with Like.
That could certainly be the case - the main sprues do have a translucent sheen to them. The footboards are on these sprues so they're...
