Rye Sands

[Andyj]

Yes it is, I've built two recently. To be honest I'm of the opposite opinion. The prickley pear kit was a real challenge (mainly due to the buffers - I've got absolutely no idea how you're supposed to drill a large enough hole for them) whereas most 3D prints are a doddle.

The quality of the 3D stuff is definitely less consistent though, but Chris's models are excellent.

Will

I think I drilled a hole close enough and then used a triangle file to open the hole out. I've done 2 of those with a 3rd in the works. Also got one of his SECR ballast wagons to do to go with some Chatham kits LBSCR ones.

 

[Willl]

I think I drilled a hole close enough and then used a triangle file to open the hole out. I've done 2 of those with a 3rd in the works. Also got one of his SECR ballast wagons to do to go with some Chatham kits LBSCR ones.

I think part of the problem is that I only have a pin vice so drilling through the buffer beams was basically impossible. I ended up chopping the buffers down but they unsurprisingly ended up wonky. The end result looks excellent though



The next layout project is now underway (it has been for a few weeks but only off/on). The theme isn't finalised but broadly speaking it will be something more urban. The initial idea was for a small goods yard, inspired by Chris Cox's Bricklayses Arms, but I'm now contemplating modelling the excavation of a cut-and-cover line, with the railway representing part of a contractor's system.

I'll be sharing more on this in the coming weeks, probably in a separate thread (unless it becomes more South Eastern!)






Will

 

[Alan]

I like your fiddle stick, might use that idea on my possible micro layout.

 

[Willl]

Thanks Alan, I will add some photos tonight showing how it works but it is basically supported by a tongue that slots into a hole on the end of the baseboard. The alignment and power is all from the fishplates, which are soldered onto copper clad sleeper/brass screws for durability.
Will