simond
Western Thunderer
Some of the metal I purchased was to make the trimmers for this.
The posts are @Jon Fitness etches.
Which will replace this which may have been “squirrelled” on JM’s outdoor line
The jig is a few 3DP pieces and provides the cross hole for the wire to the lamp, and location to solder on the pivot tube.
I shall do them later.
Progress so far is quite pleasing
Just found the previous attempt
Post in thread 'SimonD’s workbench'
SimonD’s workbench
The posts are @Jon Fitness etches.
Which will replace this which may have been “squirrelled” on JM’s outdoor line
The jig is a few 3DP pieces and provides the cross hole for the wire to the lamp, and location to solder on the pivot tube.
I shall do them later.
Progress so far is quite pleasing
Just found the previous attempt
Post in thread 'SimonD’s workbench'
SimonD’s workbench
Last edited: